11-17-2013 07:38 PM
Hi,
I'm trying to configure Cisco L2TP VPN to my office. After successful connection I cannot access to internal network.
Can you jhelp me to find out the issue?
I have Cisco ASA:
inside network - 192.168.1.0
VPN network - 192.168.168.0
I have router 192.168.1.2 and I cannot ping or get access to this router.
Here is my config:
ASA Version 8.4(3)
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 192.168.1.1 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 198.X.X.A 255.255.255.248
!
ftp mode passive
same-security-traffic permit intra-interface
object network net-all
subnet 0.0.0.0 0.0.0.0
object network vpn_local
subnet 192.168.168.0 255.255.255.0
object network inside_nw
subnet 192.168.1.0 255.255.255.0
access-list outside_access_in extended permit icmp any any echo-reply
access-list outside_access_in extended deny ip any any log
pager lines 24
logging enable
logging asdm informational
mtu inside 1500
mtu outside 1500
ip local pool sales_addresses 192.168.168.1-192.168.168.254
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
nat (inside,outside) source dynamic net-all interface
nat (inside,outside) source static inside_nw inside_nw destination static vpn_local vpn_local
nat (outside,inside) source static vpn_local vpn_local destination static inside_nw inside_nw route-lookup
!
object network vpn_local
nat (outside,outside) dynamic interface
object network inside_nw
nat (inside,outside) dynamic interface
access-group outside_access_in in interface outside
route outside 0.0.0.0 0.0.0.0 198.X.X.B 1
timeout xlate 3:00:00
timeout pat-xlate 0:00:30
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
aaa authentication enable console LOCAL
aaa authentication ssh console LOCAL
aaa authentication http console LOCAL
http server enable
http 192.168.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
crypto ipsec ikev1 transform-set my-transform-set-ikev1 esp-3des esp-sha-hmac
crypto ipsec ikev1 transform-set my-transform-set-ikev1 mode transport
crypto dynamic-map dyno 10 set ikev1 transform-set my-transform-set-ikev1
crypto map vpn 20 ipsec-isakmp dynamic dyno
crypto map vpn interface outside
crypto isakmp nat-traversal 3600
crypto ikev1 enable outside
crypto ikev1 policy 10
authentication pre-share
encryption 3des
hash sha
group 2
lifetime 86400
telnet timeout 5
ssh 192.168.1.0 255.255.255.0 inside
ssh timeout 30
console timeout 0
management-access inside
dhcpd address 192.168.1.5-192.168.1.132 inside
dhcpd dns 75.75.75.75 76.76.76.76 interface inside
dhcpd enable inside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
group-policy sales_policy internal
group-policy sales_policy attributes
dns-server value 75.75.75.75 76.76.76.76
vpn-tunnel-protocol l2tp-ipsec
username ----------
username ----------
tunnel-group DefaultRAGroup general-attributes
address-pool sales_addresses
default-group-policy sales_policy
tunnel-group DefaultRAGroup ipsec-attributes
ikev1 pre-shared-key *****
tunnel-group DefaultRAGroup ppp-attributes
authentication ms-chap-v2
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname context
no call-home reporting anonymous
Cryptochecksum:5d1fc9409c87ecdc1e06f06980de6c13
: end
Thanks for your help.
Solved! Go to Solution.
11-18-2013 12:07 AM
You have to test it with "real" traffic to 192.168.1.2 and if you use ping, you have to add icmp-inspection:
policy-map global_policy
class inspection_default
inspect icmp
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
11-17-2013 10:36 PM
Your nat-config seems wrong:
no nat (inside,outside) source dynamic net-all interface
no nat (outside,inside) source static vpn_local vpn_local destination static inside_nw inside_nw route-lookup
Sent from Cisco Technical Support iPad App
11-17-2013 11:16 PM
Can you give me advice which nat config I should use?
I've tried to delete this nat config, but still cannot ping 192.168.1.1 and 192.168.1.2
Thanks for your help.
11-18-2013 12:07 AM
You have to test it with "real" traffic to 192.168.1.2 and if you use ping, you have to add icmp-inspection:
policy-map global_policy
class inspection_default
inspect icmp
--
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni
11-18-2013 05:34 PM
Thanks for your help.
Also it's started to work after this:
object network inside-network
subnet 192.168.1.0 255.255.255.0
nat (inside,outside) source static inside-network inside-network destination static inside-network inside-network no-proxy-arp route-lookup
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide