cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3561
Views
0
Helpful
5
Replies

Cisco IOS IPSec Failover | Route-Based-VPN with HSRP

Tanveer Dewan
Level 1
Level 1

I can find IPSec vpn redundancy using Policy-Based-VPN with HSRP.

Any document that provides route-based-vpn redundancy with HSRP?

1 Accepted Solution

Accepted Solutions

Ok, I understand the question now. Sorry, I don't have any document for this task. 

I can see, that in crypto ipsec profile, which you will use under Tunnel interface configuration to enable protection, you can configure redundancy:

cisco(config)#crypto ipsec profile VTI
cisco(ipsec-profile)#?
Crypto Map configuration commands:
default Set a command to its defaults
description Description of the crypto map statement policy
dialer Dialer related commands
exit Exit from crypto map configuration mode
no Negate a command or set its defaults
redundancy Configure HA for this ipsec profile
responder-only Do not initiate SAs from this device
set Set values for encryption/decryption

cisco(ipsec-profile)#redundancy ?
WORD Redundancy group name
cisco(ipsec-profile)#redundancy MRT ?
stateful enable stateful failover


I can suggest, that it is the same as crypto map redundancy. But no documentaion or examples were found...

View solution in original post

5 Replies 5

Boris Uskov
Level 4
Level 4

Not sure, what the question is about...

As far as I know, you can use IPsec redundancy for two routers, and configure Stateful Switch Over (SSO) to synchronize IPsec databases between two routers.

This document desribes the technology:

http://www.cisco.com/c/en/us/products/collateral/ios-nx-os-software/ios-ipsec/white_paper_c11_472859.html

Thanks for the response. 

The document shows how to use HSRP with 'policy based vpn' where we use crypto acl to match interesting traffic. I on the otherhand want to use hsrp redundnacy along with 'route based vpn' where the interesting traffic is identified by a static route pointing to the tunnel interface.

Ok, I understand the question now. Sorry, I don't have any document for this task. 

I can see, that in crypto ipsec profile, which you will use under Tunnel interface configuration to enable protection, you can configure redundancy:

cisco(config)#crypto ipsec profile VTI
cisco(ipsec-profile)#?
Crypto Map configuration commands:
default Set a command to its defaults
description Description of the crypto map statement policy
dialer Dialer related commands
exit Exit from crypto map configuration mode
no Negate a command or set its defaults
redundancy Configure HA for this ipsec profile
responder-only Do not initiate SAs from this device
set Set values for encryption/decryption

cisco(ipsec-profile)#redundancy ?
WORD Redundancy group name
cisco(ipsec-profile)#redundancy MRT ?
stateful enable stateful failover


I can suggest, that it is the same as crypto map redundancy. But no documentaion or examples were found...

Hey! 

I think you are right. check this out. Its referring to the 'redundancy' command and tunnel interface both. 

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/security/m1/sec-m1-cr-book/sec-cr-r2.html#wp3201756504

Ok, thanks for link.