CSPM 3.0 failed to configure IPSec + NAT from PIX outside

[ritsang]

We're experimenting to configure a a PIX from outside using CSPM 3.0. Without NAT (Address hiding), we can successfully communicate and deploy config from CSPM 3.0 to PIX. But when we try to add NAT (Address Hiding), we found that the CSPM failed to generate correct NAT (Address Hiding) configuration.

If we move the CSPM 3.0 to PIX inside, everything works fine.... We're using PIX 5.1

Rico

[bstremp]

You’ll need to be inside to deploy the config. You might check with Cisco to see if they have some suggestions for you.

[wongsusanto]

Hi there..

I have the same problem with you.....until now there is no solution...plz let me know..if you are succesful configuring IPSEC+NAT with CSPM....

regards