DMVPN compatible with GRE/IPSEC tunnel interface?

[kjiang.mc]

Set Up:

Router spoke11 has dmvpn multimpoint tunnel11 (phy s1/0) to hub31 dmvpn multimpoint tunnel11 (phy s1/0). Router spoke11 has gre/ipsec ptp tunnel 111 (phy s1/0) to hub32 ptp gre/ipsec tunnel 111 (phy s1/0).

Router spoke12 has dmvpn multimpoint tunnel11 (phy s1/0) to hub31 dmvpn multimpoint tunnel11 (phy s1/0). Router spoke12 has gre/ipsec ptp tunnel 112 (phy s1/0) to hub32 gre/ipsec ptp tunnel 112 (phy s1/0).

Router hub31 has a dmvpn multimpoint tunnel 11 (phy s1/0). Router hub32 has two gre/ipsec ptp tunnels 111 and 112 (phy s1/0).

Eigrp 101 is running on spoke11 t111, spoke12 t112 and hub32 t111 and t112.

Eigrp 102 is running on spoke11 t11, spoke12 t11 and hub31 t11.

Problem:

Even with all eigrp disabled. T11 and T111 can not stay up. They are up for a while then invalid spi message tears them down.

Routers are 1760, 2651XM with IOS 12.4.3a advanced ip services.

Any one knows whether DMVPN multipoint interface and GRE/IPSec interface can co-exist on routers share same physical port?

Thanks in advance.

[vkapoor5]

It is not clear to me on what you are trying. From my knowledge, GRE over IPSEC will use the DMVPN multipoint interface.

[kjiang.mc]

GRE over IPSec can use DMVPN or traditional crypto map.

The problem I bumped into is on the router with legacy GRE/IPsec/Crypto.map configuration, if I configed a DMVPN multipoint tunnel interface, even mGRE went to a different destination (sharing the same source physical interface with legacy crypto.map GRE/IPsec), mGRE and GRE/IPSec/Crypto.map can not both stay up....

IOS 12.4.5, advanced services feature set.

[majsa]

Did you figure this out? Im running into the same problem as I want to connect our 2 hub locations with a GRE tunnel. I may just drop a second router in to handle the site to site but it seems like a work around as opposed to a solution.