dmvpn hub has no nhrp info, spoke is stuck in NHRP

[dgawaya1]

Hello, 
My Dmvpn hub doesn't have any nhrp state, yet the spoke is stuch in NHRP 

The hub config is here 

The spoke config is here 

I will appreciate your help 

[dgawaya1]

the tunnel is also under a customer vrf 

[Rob Ingram]

@dgawaya1 the configuration you provided today does not have the "tunnel vrf <VRFNAME>" configured. Example:

interface tunnel 0
 tunnel vrf <VRFNAME>

You only have "vrf forwarding <VRFNAME>".

[dgawaya1]

@Rob Ingram , @MHM Cisco World u guys are amazing. I got it working partly. The hub sides show up but the only one spoke is up. I will troubleshoot further. btw. I only added "tunnel vrf xxxx". I also know my routing might be a bit messy  

////Hub

///Spoke

[Rob Ingram · Accepted solution]

@dgawaya1 thats correct, I did say to configure that a couple of days ago.

You need to define the custom vrf, otherwise the router will use the global routing table to establish the tunnel to the peer. Glad it's working.

[MHM Cisco World]

So messy' You nedd to clear routing issue.

It not only tunnel vrf

MHM