01-01-2018 01:14 AM - edited 03-12-2019 04:52 AM
Hi,
I tried to config DMVPN in ISR4351 as HUB and in c1900 as Spoke
But when I test connection from spoke to hub the connection failed.
The output of (show crypto isakmp sa )commend gave me active connection
IPv4 Crypto ISAKMP SA
Dst src state conn-id status
10.10.10.5 10.10.10.1 QM_IDLE 1011 ACTIVE
But (show dmvpn)didn’t give me any result.
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
N - NATed, L - Local, X - No Socket
T1 - Route Installed, T2 - Nexthop-override
C - CTS Capable, I2 - Temporary
# Ent --> Number of NHRP entries with same NBMA peer
NHS Status: E --> Expecting Replies, R --> Responding, W --> Waiting
UpDn Time --> Up or Down Time for a Tunnel
==========================================================================
What should I do?
01-01-2018 05:17 AM
any reply ???
01-01-2018 06:35 AM
What is the output 'sh cry ips sa'?
Enable debug crypto ikev1 sa, clear the tunnel and share the output of full tunnel negotiation.
Also, keep debug ip nhrp enabled
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide