cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

DMVPN through NAT

nurbol555
Beginner
Beginner

Hello all!

i have DMVPN through  internet, 1 hub router in head office and 10 spoke routers in area, after my hub router it's firewall wich NATing hub router to internet, when i connected first spoke router, tunnel works fine, but when i added another spoke router i have a problem

NHRP-3-PAKERROR: Received Error Indication from x.x.x.x, code: loop detected

and my tunnel shuted down

command show dmvpn shows similar peer NBMA address to both spoke routers - 172.16.11.1, this addres is NATed on firewall,

what can i do on this situation? it seems like i have to see separate peer NBMA address on command show dmvpn to both routers, pls help

1 REPLY 1

Mohammad Alhyari
Cisco Employee
Cisco Employee

Can you attach a topology showing the addresses and NAT?

 

Moh,

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: