Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all!
i have DMVPN through internet, 1 hub router in head office and 10 spoke routers in area, after my hub router it's firewall wich NATing hub router to internet, when i connected first spoke router, tunnel works fine, but when i added anoth...
Hello all!
I have question about encrypted traffic on DMVPN, i have on my DMVPN tunnel crypto ipsec - esp-aes esp-sha-hmac, and 35% of all my traffic is traffic of encrtypt, is it normal?
Hello all!
I'm trying to configure two routers cisco 4431, first one will be active second one will be backup router, and i'm trying connect this routers with VRRP throught Sub interface. These two routers will be central hub for DMVPN tunnels. My q...
Hello all!
I'm trying to configure two routers cisco 4431, first one will be active second one will be backup router, and i'm trying connect this routers with HSRP throught Sub interface. These two routers will be central hub for DMVPN tunnels. My q...
Hi
Try to configure on mikrotik Firewall roles, and check connect between mikrotik and cisco, you have to see from mikrotik P2P address to cisco
Rate if it's help
Hi!
It's not a big deal, if you need create ACL for one address you just have to create ACL like that:
ip access-list extended EXAMPLE
permit udp any host 10.1.1.1 eq 500
permit udp any (or pool of public address) host 10.1.1.1 eq 4500
deny ip any h...
Hello!
You have to create interface vlan on your switch, and give this vlan on one of his port like switchport access vlan X, after that you can ping directrly switch from tftp server
Valuate if it's help!
Hello!
I suggest you to use Netflow analyzer, you can expand it on virtual server and configure your ASA to send all information from outside interface to Neflow server. And here all information will be separated, then you can see VPN throughtput i...
