Easy VPN and NAT

[henrysacco]

Trying to connect a remote site to our corporate network via easy vpn. Cant seem to get it working.

Corporate network has a PIX 520 and the remote site has a PIX 501.

The remote site is a small office with a cable modem and a linksys router (i cant replace the linksys). The 501 is plugged into the linksys with a static 192.168.x.x address.

Is it possible my problem is the fact that the 501 is using a NAT address?

Would there be something special i need to enable on the 501 to make this work?

[jay_colby]

You will need to make sure both sides have 6.3. Once you have that the host end needs this command.

isakmp nat-traversal

This will allow the pixes to neg. Nat-T. Allowing the connection through the nat device.