Firepower 2110 between ISR C-921 router site to site vpn
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-30-2022 07:41 PM
Can i create site to site VPN Firepower 2110 between ISR C-921 router?
What configuration on Firepower and ISR C-921?
Please guide, manual?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2022 03:37 AM
here is config to be done on FTD :
same config need to replicated other side.
you can use below reference guide : configuring router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-31-2022 07:49 AM
@Lkhagvajav Ganbaatar I assume you are running the FTD image on the 2110, rather than the ASA image?
Best to run a VTI between the firepower 2110 device as a crypto map (Policy Based VPN) is depreciated on newer IOS versions. Here is an example to setup a VTI on FTD image https://integratingit.wordpress.com/2020/12/27/ftd-6-7-route-based-vpn-vti/
Here is an example to setup a VTI on IOS image. https://integratingit.wordpress.com/2016/07/07/configuring-cisco-flexvpn-svti/