FirePower CLI redirect "Show" output

[dpditstaff]

I am running the following command in the CLI of a FirePower 1040 and receive the error message "Syntax Error:  Illegal Parameter"

> show vpn-sessiondb anyconnect | redirect tftp://1.2.3.4/running-config.txt

can someone please shed some light on the correct syntax for this command when running from the FDM command line?

Thank you!!

[Pavan Gundu]

The CLI presented in FDM GUI is too limited, and I don't believe there is a way to do it from the GUI.

You can do SSH to the device or console into it to run the same command and it should do the job.

[dpditstaff]

Thank you for the reply.  We have SSH into the device and executed the command but receive the error message.

What is the correct syntax for this command?

Thank you!

[Pavan Gundu · Accepted solution]

Did you enter the diagnostic CLI mode?

> system support diagnostic-cli

firepower> en
Password:

The enable password is empty. Try running the command again and see if it works.

[MHM Cisco World]

show and redirect I dont think this work, 
what I know there is export/import webvpn and also this not included the sessiondb. 

I will make check and update you if find something useful.

Thanks A Lot
MHM

[dpditstaff]

Greetings  -  After changing to the diagnostic CLI, I was able to successfully execute the command.

Thanks for the information.

[MHM Cisco World]

Thanks a lot for update us.

Can you confirm that exact command work?

Thanks A Lot
MHM