- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 12:13 PM
I'm hoping someone out there has an easy fix for this problem. Firepower 1140 when I connect using Anyconnects I can access all Cisco devices via putty or web gui, but cannot access the Firepower working at home I keep connecting to my home router when putting IP of firepower into browser, and putty fails out. I changed the default port number on the HTTPS Data port to something besides 443. Still can not access the Firepower.
I can access the Firepower from our old VPN connection, but am trying to get that connection off line by end of month.
Any info is appreciated.
Thanks,
Solved! Go to Solution.
- Labels:
-
Remote Access
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 02:21 PM
@00u18jg7x27DHjRMh5d7 configure the command management-access inside - where "inside" is the nameif of your inside interface you are connecting to via SSH/HTTPS over the VPN. You have to configure this using FlexConfig.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 12:18 PM
@00u18jg7x27DHjRMh5d7 I assume you are using FDM to manage the firewall? Have you define the networks that can access the FDM on the management or data interfaces? Go to System Settings > Management Access and check to see if the RAVPN pool IP address is permitted to connect.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 12:35 PM
I have the VPN network access for management and data port still getting the same issue. Trying to change home modem IP see if that stops the issue.
Gladly take any other suggestions.
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-18-2022 02:21 PM
@00u18jg7x27DHjRMh5d7 configure the command management-access inside - where "inside" is the nameif of your inside interface you are connecting to via SSH/HTTPS over the VPN. You have to configure this using FlexConfig.
