GCP HA VPN to FTD

[Chess Norris]

Hello,

A customer have a working GCP classic VPN tunnel to a FTD device. The tunnel on the FTD side is policy-based. 

Now the customer need to change from GCP classic to GCP HA and I'm trying to find information on what I need to change on the FTD side? The only thing I could found was this document describing a HA VPN beteen GCP and a Cisco ASA 5506H  https://github.com/GoogleCloudPlatform/community/blob/master/archived/using-ha-vpn-with-cisco-asa/index.md 

I guess I need to change from Policy-based to route-based in FTD, but are there anything else needed?

Thanks

/Chess

[Rob Ingram]

@Chess Norris it is pretty straightforward from the FTD perspective.

Disable the old policy based VPN configuration, create a new sVTI and configure BGP routing. https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/216276-configure-route-based-site-to-site-vpn-t.html

If you need to peer to different GCP gateways, then you can configure a backup VTI on the FTD.

https://www.cisco.com/c/en/us/td/docs/security/secure-firewall/management-center/device-config/740/management-center-device-config-74/vpn-s2s.html#Cisco_Reference.dita_73dac582-5114-4643-9536-fc4e2de1f1c4

[Chess Norris]

Thank you, Rob. So BGP it's mandatory? A static route won't work?

Thnaks

/Chess

[Rob Ingram · Accepted solution]

@Chess Norris yes static routing is supported. If you were setting up an HA VPN to multi peer hubs, a routing protocol is recommended.

[Chess Norris]

Thanks again. Will give it a try next week.

/Chess

[MHM Cisco World]

Sorry FTD have one WAN and cloud providers two public IP?

MHM