01-18-2011 04:00 AM
Hi,
I'm implementing GET VPN and want the KS to be GM as well... Is this possible?
Thanks
/JZN
Solved! Go to Solution.
01-18-2011 04:26 AM
No, KS can not be configured as a GM.
Here is the document to support that:
Quote from page 6:
Note: A device acting as a KS cannot be configured as a GM
Hope that answers your question.
01-18-2011 04:26 AM
No, KS can not be configured as a GM.
Here is the document to support that:
Quote from page 6:
Note: A device acting as a KS cannot be configured as a GM
Hope that answers your question.
01-18-2011 06:17 AM
Thank you so much. I've been over and over the pdf without see this fact.
I wanted to combine the KS with a DMVPN hub for implementing GET VPN over the internet... Too bad I have to buy the double amount of routers for this scenario.
But thanks again for pointing out the fact.
/JZN
01-18-2011 02:34 PM
No worries, happy to help. Please kindly mark the post as answered so others can learn from your post.
08-05-2011 08:45 AM
Interesting....... I am actually running a KS/GM combination with no problems. I asked for a bug enhancement from Cisco: CSCsa78126. I'm am challenging this scenario. I have two CE routers at a location - one is a GM, and the other is a KS/GM - we are running a primary/secondary failover (HSRP) peering with two firewalls; we've run failovers between each of the two mentioned routers and not experienced any issues with authentications, keyings, etc. I know this isn't best practice, but sometimes its tough to do the "exact"
Just my 2 cents,
Chris
08-29-2012 04:57 AM
Dear Clonac ,,
cau you tell me how you configure the KS and GM on the same router ? and what is the router Model and IOS Version ,,,
also kindly can you send me the configuration ?
Regards
Ossamy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide