Hello,
I would like to know if it's possible to configure a GRE tunnel in a vrf using the GRT as underlay?
For example, this configuration (source):
interface Tunnel0
ip vrf forwarding green
ip address 200.200.200.3 255.255.255.0
tunnel source Ethernet0/0
tunnel destination 10.10.10.1
tunnel vrf blue
!--- Tunnel 0 is part of VRF GREEN; but it uses the tunnel
!--- destination and source addresses from the routing
!--- table of VRF BLUE, because of this tunnel vrf blue
!--- command.
But, instead of using vrf blue routing table for the source and destination addresses, I want to use the GRT routing table.
Thank you for your help.
Thomas