How do i setup AnyConnect VPN on my 1941 cisco router

[Maambo]

the command line is showing me this

R1#config
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#webvpn ?
% Unrecognized command
R1(config)#crypto vpn ?
% Unrecognized command

R1#sh licence

StoreIndex: 0 Feature: ipbasek9 Version: 1.0
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
StoreIndex: 1 Feature: SSL_VPN Version: 1.0
License Type: Permanent
License State: Active, Not in Use
License Count: 10/0/0 (Active/In-use/Violation)
License Priority: Medium
License Store: Built-In License Storage
StoreIndex: 0 Feature: securityk9 Version: 1.0
License Type: EvalRightToUse
License State: Active, Not in Use, EULA accepted
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
Period used: 0 minute 0 second
License Count: Non-Counted
License Priority: Low
StoreIndex: 1 Feature: datak9 Version: 1.0
License Type: EvalRightToUse
License State: Active, Not in Use, EULA not accepted
Evaluation total period: 8  weeks 4  days

[b.winter]

@Maambo Honest question: What has your question to do with Collaboration?

[Maambo]

Sorry beginner error... I will be careful next time

[M02@rt37]

No problem @Maambo!

[M02@rt37 · Accepted solution]

Hello @Maambo,

It seems that you have an SSL VPN license ("SSL_VPN") that is "Active, Not in Use." You need to activate this license to use SSL VPN features. To activate the license:

license accept end user agreement

This command will accept the end-user license agreement for the SSL VPN license.

After that do a Reload.

N.B: Please check the forum title before posting a question/an issue.

[Maambo]

Thats the error i  am receiving 

R1#license accept end user agreement
^
% Invalid input detected at '^' marker.

R1#

[M02@rt37]

@Maambo 

Under config-terminal.