how to determine anyconnect license usage

[ronald.su]

I wonding how many anyconnect session rightnow on the ASA. 

since we have 50 concurrent session anyconenct license, I wanna know the usage. if reach 95%, we need to ocnsider expand the lincense....

thanks

[Francesco Molino]

Hi

When ssh to the box, you can run the command show vpn-sessiondb summary to see how many VPN sessions are up.

[ronald.su]

in below screenshot, how many anyconnect license counted ? 3 or 6 ?

[Sheraz.Salim]

show vpn-sessiondb summary

[Francesco Molino · Accepted solution]

You should check the one at the top written anyconnect client. This is showing you you have 3 clients.
If you do the same command with anyconnect instead of summary, you should see 3 sessions.

[nirmal.joshi]

Is there a way from CLI or GUI of Cisco Firewalls to check which AnyConnect license is used from VPNO/Apex/Plus?

The Apex licenses are subscription based so would it also show perpetual in the CLI output attached.

 Need some immediate clarity on this.

Thanks

Nirmal

[Francesco Molino]

If you run the command show vpn-sessiondb anyconnect you should have a license info line on a per connection basis

[nirmal.joshi]

Thanks but does it tell which one is in use VPNO or Apex or Plus?

Regards

Nirmal Joshi

[Francesco Molino]

It'll give you an information about the license used depending if it's a mobile user or laptop user. Not sure it'll says plus or apex.
Can you try it and share the output please to see?