interface on 3825 for remote access

[dom.a]

Hi,

I have 10 remote site with a PC connected to an analog modem and a phone connection to the PSTN. In the main site I have a 3825 and a E1 line. I want to know the type of card i have to use on the 3825 in order to perform remote access for my 10 remote site.

Regards

[pkhatri]

Howdy,

You could use the NM-12DM (12 Port Digital Modem Network Module) in order to terminate these calls.

Hope that helps - pls rate the post if it does.

Regards,

Paresh

[dom.a]

Hi,

Ok but the NM-12DM network modules do not provide interface on their own.In addition to the digital modem module, the router must contain a PRI or BRI interface to connect to the ISDN channel. The pb is that i have only one slot for NM module available.

So another solution would be suitable for me.

Regards

[pkhatri]

How about getting a VWIC-1MFT-E1 for your E1 ?

Paresh

[dom.a]

Yes,

I think the VWIC-1MFT-E1 card is the right one.

Also have you got a configuration example for my case ?? or a goog link about a sample config ?

Thank a lot !!