ASA acting as a VPN server for incomgin client connections. The ASA outside interface has a 192.168.8.X address. Infront of the ASA is a internet connected firewall that has a one to one NAT mapping from a public routable IP to the ASA's outside interface. I have no visibility into the firewall doing the NAT but they tell me they have the relevent IPsec ports allowed.
The client fails to connect and I see virtually no traffic on the ASA for the connection attempt. Assuming the right ports are allowed NAT is the most likely cause for this failure? Can someone give some detail on how NAT would be breaking it.
Make sure the allow UDP 4500 In addition to just UDP 500 and IP protocol 50. When either end is behind a NAT device (client or headend) UDP 4500 starts getting used once both ends realize one of them is behind NAT.
Other than that, make sure that you have 'crypto isakmp nat-traversal' enabled. You show see it in the config if you do a 'show run all crypto isakmp nat-traversal'.
So are you saying that I can connect a client VPN to an ASA with a non public IP provided another device infront of it e.g. a Juniper\Checkpoint firewall etc is doing one to one NAT for that ASA to a public IP?
I thought you couldnt do that or is the UDP 4500 the NAT traversal thats taking care of this?
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 188.8.131.52Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 184.108.40.206R1(config-ikev2-keyring-pee...
This document shows how to use the Port Radius NAS PORT Id Attribute in a compound condition to control access with 802.1X.A user jdoe is allowed to access the network only through the physical port FastEthernet 0/1 of the switch and the user jwhite is al...
This document provides a configuration example of Security Assertion Markup Language (SAML) Authentication on FTD managed over FDM. The configuration allows Anyconnect users to establish a VPN session authenticating with a SAML Identity Serv...
DMVPN Dual Hub Dual Cloud Pros and ConsProsNo single point of failureQuick failover if routing protocols are tunedLoad balancing is easyTraffic engineering is easyEasy to work with multiple ISPsConsNeed 2 tunnels per spokeConfiguration is more complicated...