Hello.
I have a question regarding the feature called "MPLS VPN o mGRE" Iam guessing it is L3vpn configuration that is meant (that is what you get when you google the function) or the 2547oDMVPN feature. The cisco feature navigator says that it is supported but i cannot seem to get it to work.
The l3vpn syntax dosent work
881-CPE(config)#l3vpn
^
% Invalid input detected at '^' marker.
881-CPE(config)#
And the ordinary mpls ip under tunnel interface dosent either seem to work.
881-CPE(config)#int tunnel 1
881-CPE(config-if)#mpl
881-CPE(config-if)#mpls ip
^
% Invalid input detected at '^' marker.
881-CPE(config-if)#
Has anyone tried this feature and can give a hand on how the syntax is or is the feature navigator just plain wrong?
Attaching a screenshoot from the Feature navigator.
