need basic config of Access VPN

[chirapandya]

hello Sir,

i have knowledge of Site-to-Site VPN but i am so much confused in access vpn.i can not get proper idea of access VPN.

So please give me some basic idea of access vpn and some basic examples so i could get proper idea and impliment it on my live network.

Thanking You,

Chirag Pandya

Network admin

GSWAN

[mhussein]

Hello,

You didn't specify what platform you are using (pix, router/switch, or concentrator), anyway, this is a long list of IPSec configuration examples:

http://www.cisco.com/en/US/tech/tk583/tk372/tech_configuration_examples_list.html

HTH,

Mustafa

[chirapandya]

hellos Sir,

Thx for your reply.i want basic knowledge of remote access vpn. how its work ? how its recognise ?

which type of VPN is good for different network ? and how to configure it.

I want to learn it first from basic and theoriticaly. so plz help me out in this

Thankign You,

Chirag Pandya

Network Admin

GSWAN

[PE-PatInBC]

Hello Chirag,

I am currently configuring our PIX for Remote Access VPN Clients also. I have done this once before but it was a while ago and was working with someone that was more familiar than I. Below is a link from what Mustafa sent you that gives what I believe is some basic info on a fairly basic configuration similar to what I did before. I don't think I'm up to doing this one at the command line so am going to try the VPN Wizard from within PDM and it may or may not make it easier. If, (when) I am successful, I will let you know.

http://www.cisco.com/en/US/products/sw/secursw/ps2308/products_configuration_example09186a00801e71c0.shtml

Good luck,

PE-Patinbc

[chirapandya]

Hello Patinbc,

Thx for your reply. This document is very useful for me but Patin i want some basic knowledge of how to recongnise the configuration of VPN.

I need some basics about VPN, how its basic working methods and how can i configure any type of VPN configuration.

I have many type of config examples but i want to recognise each and every command , why that commnad use and what is the definition of that command.

Thx to listen me.

Thanking You,

chirag Pandya

Network Admin

GSWAN