cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
630
Views
0
Helpful
3
Replies

Not able to configure serial interface for dialout using external modem

kapoors
Level 1
Level 1

I have 2610 and i want dialout to Cisco RAS PRI using serial interface on which external modem is connected

3 Replies 3

makchitale
Level 6
Level 6

What type of serial interface do we have here? Async serial or sync serial? Also what type of external modems do we have here?

I would assume you have a async external modem & need to connect the same to an asyn port on the 2600, a similar config is seen below (he modem is connected to aux port for dialout)

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_configuration_example09186a0080094579.shtml

If you have an async/sync module then inorder to make it asyn will need to add the command "physical-layer async"

conf term

interface serial x

physical-layer async

Thanks, Mak

kapoors
Level 1
Level 1

I have sync serial interface and DLINK modem.

The modem connections and cables are ok , i have tested by reverse telnet.

It is still not working , i am getting any output of debug chat for dial out

Sorry for the bad news but a synchronous serial port can not communication with a asynchronous modem. You must use a asychronous port. I'm not for sure wether the 2610 as both A/S port.

HTH

Bill