VPN

HiWe have a 1701 connected via ADSL with IPSEC with our PIX515UR. We would like to know how to configure the 1701 to have a ISDN backup of the ADSL if it fails.The ISDN backup stablishes a IPSEC VPN with the PIX 515UR.Note:-the ADSL have fixed IP add...

I am trying to access a 2600 series router remotely. But I get the message "% connection refused by remote host". This message is obtained on both WAN and LAN telnet attempts. But the router itself functions perfectly. There is no problem with the fu...

I have a Cisco 837 router. I have to connect to my adsl provider using RFC 1483 (bridge). The pvc is 0/32.I have attached the following documents:- router config file;- the output of the command "show version".The router is functioning well, but for ...

I have a user that was connected to our PIX, disconnected, and now can't reconnect. The connection doesn't show up anywhere but the sh isakmp sa output where it shows as QM_IDLE but the user isn't currently connected. When the user try’s to connect...

Hi..i have configured my access server to accept ISDN dialup calls (128K), and made call from windowsXP to this AS, the authentication and the authorization from ACS 3.0.After debug messages, it seems that the problem from AAA authorization because t...

I have 2610 and i want dialout to Cisco RAS PRI using serial interface on which external modem is connected

Two following "dialer map" command was configured under interface BRI0, But it caused different connection type in routing table. "10.10.1.1" and "10.10.10.11" were loopback addresses on another router.________________________________________________...

We're trying to implement certificates on our VPN 3060s. I can get it working great until I enable CRL checking. According to the log, the concentrator sucessfully retrieves the CRL.I get the following errors:1381 12/29/2004 11:17:19.670 SEV=3 CAPI...

Hi.I'm using CiscoSecureACS to configure an external group on my vpn 3000 concentrator.I don't understand why some attributes (like split) are not correctly set on IPSec tunnel!Suggestion?Thanks.Andrea.

Before setting 'timeout conn 8:00:00' from I think 10min the vpn client would timeout often. Now that's pretty good the client tunnel stays open.Since then I've also added 'isakmp keepalive 10' to the pix and 'ForceKeepalives=1' in the client config...

Hello,Is it possible to enforce the connection timeouts on a vpn client with full time connections to upodate servers like MS Update, ZoneAlarm update, etc.?Thanks!

Hi.Our company currently has a VPN 3015 concetrator, running IOS 4.01. From what we have been able to figure out, there is a 100 user combined user&group limit. Is this a limitation of the IOS or of the concentrator itself. Any workarounds for this?T...

I have a 3640 with NM-8BRI and 6MICA-MDM and everything is working fine. ISDN DDR, Async Dialin, Async Dialout.I'd like to add ISDN Dilaout for our users, I've tried setting connecting with Hyperterminal, setting ATS29=8ATDI 034343443344I am using Di...