pinout doubt

[d-fernandes]

Hi,

I have a cisco 2610XM that is used as terminal server. I would like to create a remote access through the PSTN network using the “WAN Interface Card - One Port Analog Modem”. From the router side the interface is RJ-11 and from PBX side the interface is RJ-45. What is the pinout that I must use?

Regards

[lgijssel]

PSTN generally uses the two pins in the center of the connector. (4,5 on RJ45, 2,3 on RJ11.

Goodluck,

Leo

[renoufi]

I use the NM-16AM-V92 which is a 16 port version of the one port WIC.

You use the centre two pins on the WIC (RJ45).

You would normally use only the centre pins on the RJ-11, but you would need to check the wiring to be sure.

[daysleeper]

i think that you need to know the pinout from pbx side,

the pinout of wic-1am is the two central pin.