Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure a Cisco 1941 to use a cell network with a EHWIC-3G-HSPA+7 card It auto generates the following command:chat-script hspa-R7 "" "AT!SCACT=1,1" TIMEOUT 60 "OK" Most cell configs I've seen use a chat-script similar to the followin...
Has anyone found alternative power injectors to the AIR-PWRINJ1500-2?I'm looking to power AIR-CAP1552E-N-K9 from a DIN rail mount injector or multiport midspan.TIA
After recently upgrading to 7.2.110.0 and WCS to NCS 1.0 my advice would be.....don't do it.I am only posting this here so that others who may be experiencing pain from this upgrade or are contemplating the upgrade are aware of some of the pitfalls.I...
I have a pair of ASA5520s in Active/standby.I have a bunch of devices on a VLAN that currently use .254 as the gateway address that I want to eventually migrate to .1 as the gateway adress.If I configure:ip address 192.168.170.1 255.255.255.0 standby...
I know it's an old one but just an FYI for any others that may trip over this thread:I have had multiple Cisco products (mostly wireless) that refuse to work with a serial/USB converter on a laptop but work perfectly with the serial port on the same ...
I had a similar issue with a 5508x. Went to a lot of trouble to get a the resistor put in but it wouldn't boot. Was very disappointed. Then I removed the CMOS battery, shorted out the pins.....and presto.....working 5508......
As long as the resistance value is right, any resistor will be ok. It'll depend on your soldering skills, quality of the magnifying glass and whether you can physically get it soldered to the board......
I just tried that trick on a completely dead 5508 (no lights at all)Unfortunately, the result was to restore the orange flashing light of death, but no other function
