Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a cisco 2610XM that is used as terminal server. I would like to create a remote access through the PSTN network using the WAN Interface Card - One Port Analog Modem. From the router side the interface is RJ-11 and from PBX side the inter...
Hi,I have two CSS11503 and one is active (CSS1) and other is standby (CSS2). However when I made the command sh system-resources I have the following output:CSS1# sh system-resources System Resources for 1/1: Installed Memory: 268,435,456 (256 MB) ...
The following problem happened in my network:I have two 12406 with IOS Version 12.0(27)S5 (RTR1&RTR2) that make the Internet access from my company through my Service Provider where I have BGP neighbour and I received the Internet full routing table....
Hi,I have a Catalayst 6506 and now i will put the supervisor 720-3BXL. I can´t find in the Cisco Documentation any documentation relating to the design architecture of the Catalayst 6506 and the Sup-720. Can anyone help me with this?
Martin,I saw the LFIB and CEF entries for the default route in the core routers under the various conditions and it seemed to be Ok. Due to loss of service that occurred I not be able to make more exhaustive troubleshooting.But I will replicate in la...
Hi Martin,The core routers have the default route entry through RTR2 but the core router doesnt use the default-route to deliver the traffic. The core routers have the Internet full routing table. I have the mpls ip default-route command active.Rega...