PIX to PIX RAS VPN

[phlitservices]

Hi all,

I?m trying to connect to a remote site that is protected by a PIX 501 using the cisco vpn client. I can connect to the remote site if I go through a dialup or any other dsl connection, however, I cannot connect from our main office which is also protected by a PIX 506e. The PIX 506e is also configured for RAS VPN.

Cisco VPN Client (v4.x)--->PIX506--->Cisco827AdslRtr-->INTERNET<---Destination PIX501<--LAN

When I view the syslog from the pix 506e which is protecting my connection, I?m getting the following message ?%PIX-3-305006: portmap translation creation failed for protocol 50 src inside 172.16.1.132 dst outside:66.6.x.x?

Any assistance is appreciated

Don

[Fernando_Meza]

try adding the fixup protocol esp-ike this however will aloow only one connection at a time. Otherwise I suggest you using the PIX506e as VPN client to the 501 PIX. In that way you don't need to connect using the cisco VPN client installed on the user's PC.

I hope it helps .. please rate if it does !!