Posture Assessment Troubleshooting

[ejdrijin1]

I am currently trying to set up a Remote Access VPN connection with some posture assessment and the client cannot connect as it is saying Posture Assessment: failed. Any logs I can check or any guidelines?

Thanks

[Shakti Kumar]

hello

Below support forum doc will definitely prove helpful

https://supportforums.cisco.com/document/12205416/information-acquire-dap-troubleshootinghttps://supportforums.cisco.com/document/12205416/information-acquire-dap-troubleshooting

Thanks

Shakti

[Rahul Govindan]

Are you using the ISE Posture with Anyconnect or the ASA Posture using Hostscan? For ISE, you can look at the Posture report for that endpoint that failed. For the Anyconnect client, you can look at the DART bundle after a failed attempt to see what went wrong. Collecting the DART is here:

https://supportforums.cisco.com/document/12747756/how-collect-dart-bundle-anyconnect

On the ASA side, you can run the following debug for DAP to see what endpoint parameters are being sent via Hostscan:

debug dap trace

[ejdrijin1]

Thanks.