03-06-2005 07:56 PM
Hi
I need to know if the WIC-1AM modem supports caller ID. If so can you point me at the IOS commands that I need to configure and utilise this.
03-07-2005 08:40 AM
None of the Analog modem supports caller-ID detection on the modem itself. You can have analog phone connected behind the analog modems which can show the caller-id for incoming call but modem doesn't support that.
Not sure what is the requirements using caller-id on the modem calls.
03-07-2005 02:30 PM
Hi, according to the manual I found for the modem, the command AT+VCID=1 enables caller id. However when I use it on a line with caller id I get no output.
We wish to use caller-id as extra layer of security for OOB management of a router. i.e. it will only answer calls from a line(s) in our network ops centre.
I have done as you mentioned and connected a caller-id unit on the phone port of the WIC-1AM and it works ok. So the id data is definately reaching the module.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: