RAS on 3845 cannot get the PRI to become established

[rbradfield]

just moving over to the 3845 router from a 3660 we have an e1 pri used for modem dial in no probs on 3660 with digital mica modems, but on the 3845 it always wants to make it a voice configuration, when I shut down the voice-port and change the encapsulation to PPP the ISDN goes from "multiple-frame-established" to "awaiting-establishment"

How do I cure this problem? I think it has something to do with the DSPs and the "network-clock-participate" command

on the controller E1 it will not let me do a pri-group timeslots 1-31 command with out the network-clock-participate wic 0 command, then whe I do that it generates the serial interface for voice, which i dont want.

anybody had this problem

[Georg Pauwen]

Hello,

which card are you using (e.g. VWIC-1MFT-E1) ?

Regards,

GP

[rbradfield]

thanks for your response yes using a VWIC-1MFT-E1,

yes and I checked it only supports voice not data and modem, so have ordered a NM-1CE1T1-PRI

RB

[Georg Pauwen]

Hello RB,

right...no data with that card. I hope you can get a refund...:)

GP