02-19-2014 12:40 AM
We are trying to confgirure a VPN site to site using two RV110W.
In first site we have this network:
Router ADSL:
Router RV110W:
In second site:
Router ADSL:
Router RV110W:
At "Basic VPN Setup" we configure with this values:
First site:
Second site:
When save this configuration seems that all is OK, but the state of IPSec Connection is "IPSec SA not established".
The log of the router in the first site is:
1 2014-02-19 9:34:20 AM debug pluto[2627]: "vpnEmpsoft" #23: received and ignored informational message
2 2014-02-19 9:34:20 AM debug pluto[2627]: "vpnEmpsoft" #23: ignoring informational payload, type INVALID_ID_INFORMATION msgid=00000000
3 2014-02-19 9:34:20 AM debug pluto[2627]: "vpnEmpsoft" #23: discarding duplicate packet; already STATE_MAIN_I3
4 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: received and ignored informational message
5 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: ignoring informational payload, type INVALID_ID_INFORMATION msgid=00000000
6 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: STATE_MAIN_I3: sent MI3, expecting MR3
7 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: transition from state STATE_MAIN_I2 to state STATE_MAIN_I3
8 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: STATE_MAIN_I2: sent MI2, expecting MR2
9 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: transition from state STATE_MAIN_I1 to state STATE_MAIN_I2
10 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: received Vendor ID payload [Dead Peer Detection]
11 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: received Vendor ID payload [Openswan (this version) 2.6.21 ]
12 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #23: initiating Main Mode to replace #22
13 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #22: starting keying attempt 2 of an unlimited number
14 2014-02-19 9:34:10 AM debug pluto[2627]: "vpnEmpsoft" #22: max number of retransmissions (2) reached STATE_MAIN_I3. Possible authentication failure: no acceptable response to our first encrypted message
15 2014-02-19 9:33:30 AM debug pluto[2627]: "vpnEmpsoft" #22: received and ignored informational message
16 2014-02-19 9:33:30 AM debug pluto[2627]: "vpnEmpsoft" #22: ignoring informational payload, type INVALID_ID_INFORMATION msgid=00000000
17 2014-02-19 9:33:30 AM debug pluto[2627]: "vpnEmpsoft" #22: discarding duplicate packet; already STATE_MAIN_I3
18 2014-02-19 9:33:10 AM debug pluto[2627]: "vpnEmpsoft" #22: received and ignored informational message
19 2014-02-19 9:33:10 AM debug pluto[2627]: "vpnEmpsoft" #22: ignoring informational payload, type INVALID_ID_INFORMATION msgid=00000000
20 2014-02-19 9:33:10 AM debug pluto[2627]: "vpnEmpsoft" #22: discarding duplicate packet; already STATE_MAIN_I3
21 2014-02-19 9:33:01 AM debug pluto[2627]: "vpnEmpsoft" #22: received and ignored informational message
22 2014-02-19 9:33:01 AM debug pluto[2627]: "vpnEmpsoft" #22: ignoring informational payload, type INVALID_ID_INFORMATION msgid=00000000
23 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: STATE_MAIN_I3: sent MI3, expecting MR3
24 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: transition from state STATE_MAIN_I2 to state STATE_MAIN_I3
25 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: STATE_MAIN_I2: sent MI2, expecting MR2
26 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: transition from state STATE_MAIN_I1 to state STATE_MAIN_I2
27 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: received Vendor ID payload [Dead Peer Detection]
28 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: received Vendor ID payload [Openswan (this version) 2.6.21 ]
29 2014-02-19 9:33:00 AM debug pluto[2627]: "vpnEmpsoft" #22: initiating Main Mode to replace #21
30 2014-02-19 9:33:00 AM debug pluto[2627]: pending Quick Mode with 218.128.53.113 "vpnEmpsoft" took too long -- replacing phase 1
The log of the router in the second site is:
1 2014-02-19 9:29:30 AM debug pluto[1002]: "vpnEmpsoft" #53: sending encrypted notification INVALID_ID_INFORMATION to 218.128.53.114:500
2 2014-02-19 9:29:30 AM debug pluto[1002]: "vpnEmpsoft" #53: no suitable connection for peer '192.168.0.1'
3 2014-02-19 9:29:30 AM debug pluto[1002]: "vpnEmpsoft" #53: Main mode peer ID is ID_IPV4_ADDR: '192.168.0.1'
4 2014-02-19 9:29:20 AM debug pluto[1002]: "vpnEmpsoft" #51: max number of retransmissions (2) reached STATE_MAIN_R2
5 2014-02-19 9:29:10 AM debug pluto[1002]: "vpnEmpsoft" #53: sending encrypted notification INVALID_ID_INFORMATION to 218.128.53.114:500
6 2014-02-19 9:29:10 AM debug pluto[1002]: "vpnEmpsoft" #53: no suitable connection for peer '192.168.0.1'
7 2014-02-19 9:29:10 AM debug pluto[1002]: "vpnEmpsoft" #53: Main mode peer ID is ID_IPV4_ADDR: '192.168.0.1'
8 2014-02-19 9:29:01 AM debug pluto[1002]: "vpnEmpsoft" #53: sending encrypted notification INVALID_ID_INFORMATION to 218.128.53.114:500
9 2014-02-19 9:29:01 AM debug pluto[1002]: "vpnEmpsoft" #53: no suitable connection for peer '192.168.0.1'
10 2014-02-19 9:29:01 AM debug pluto[1002]: "vpnEmpsoft" #53: Main mode peer ID is ID_IPV4_ADDR: '192.168.0.1'
11 2014-02-19 9:29:00 AM debug pluto[1002]: "vpnEmpsoft" #53: STATE_MAIN_R2: sent MR2, expecting MI3
12 2014-02-19 9:29:00 AM debug pluto[1002]: "vpnEmpsoft" #53: transition from state STATE_MAIN_R1 to state STATE_MAIN_R2
13 2014-02-19 9:29:00 AM debug pluto[1002]: "vpnEmpsoft" #53: STATE_MAIN_R1: sent MR1, expecting MI2
14 2014-02-19 9:29:00 AM debug pluto[1002]: "vpnEmpsoft" #53: transition from state STATE_MAIN_R0 to state STATE_MAIN_R1
15 2014-02-19 9:29:00 AM debug pluto[1002]: "vpnEmpsoft" #53: responding to Main Mode
16 2014-02-19 9:29:00 AM debug pluto[1002]: packet from 218.128.53.114:500: received Vendor ID payload [Dead Peer Detection]
17 2014-02-19 9:29:00 AM debug pluto[1002]: packet from 218.128.53.114:500: received Vendor ID payload [Openswan (this version) 2.6.21 ]
¿what is the problem?
We try to configure ther routers connecting directly WAN connections and works fine (changing the Remote WAN ip adress, of course). It's seems that the problem is when there are 2 routers adsl between the cisco RV110W.
04-20-2014 05:45 PM
I have the exact same configuration with: (2) RV110W, ADSL, and P2P VPN and I am receiving the same exact log messages.
Any help out there?
Thank you
04-20-2014 08:41 PM
Hi Empsoftsl,
Could you please confirm that PFS is disabled on both the ends. If not could you please try disabling and then initiating the connection.
Vishnu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide