VPN

Hi, I'm trying to find the command/s so that when a Cisco Anyconnect client connects to a router it get's added to a specific VRF. I know this is possible via the standard Cisco VPN client but cannot find information on how to get Cisco Anyconnect pr...

 We have a few cisco routers connected via anyconnect vpn to our asa. The tx and rx counters seem to be very high, even with no usage.Over 3hours the counters are 200,000,000+ bytes each with no usage. My calculation is that is like 190Mb while idle....

Hi  all ,  I have problem with DMVPN tunnels . Using 3G as backup on 880 router . After reboot of router 3G is working but dmvpn do not work . Any solution ? Some help ?On HUB i get this     0 UNKNOWN             172.29.3.26  NHRP    never    IX on S...

I am setting up a L2L with a supplier.  Is there any way to limit access through the tunnel similar to security levels between interfaces.  I would like the remote side of the tunnel to not be able to initiate the traffic.

I might be behind the times here but any advice would be appreciated. I have a new Windows 7 laptop and I cannot install the Cisco VPN client software. It complains that it isn't true 64-bit. I have tried compatability mode and running as administrat...

We have an ASA5520 with multiple site to site VPN, there is one particular tunnel that the customer can't seem to consistently iniate the tunnel. The other tunnels work fine. They are using a low end DSL Cisco router, 881W. So we end up initiating th...

Hi, We have a requirement where we need to create multiple site-to-site VPN on Cisco routers running IOS 15.1, having 2 different source interfaces, i.e VPN1 using Loopback1 and VPN2 using Loopback2 How can we achieve this ? We have a limitation of d...

Hi,This is pulling my hair out! Must be overlooking something very simple!Simple lab setup with 3 routers. VPN setup between R1 & R3 with static routing. R2 connects R1 & R3. All interfaces are reachable, including loopbacks. I am trying to encrypt t...

I want to require AnyConnect users to have antivirus installed, enabled, and updated within the last 30 days, but don't want to maintain a list of products they're permitted to use.  AVAST, for example, isn't among the available options via the ASDM ...

Would very much appreciate some assistance configuring client/server VPN on 1841 Cisco IOS Software, 1841 Software (C1841-ADVSECURITYK9-M), Version 12.4(25g)CISCO_1841#sho runBuilding configuration...Current configuration : 6155 bytes!! Last configur...

Hi all, any idea on thisThe Anyconnect module does not detect McAfee VirusScan version 8.8.0 (8.8.0.1247)VirusScan version 8.8.0 (8.8.0.849) was well detected. thanks in advanceLance

Hello! Can I setup a Witopia VPN (IPSec) connection to a Cisco CVR100W? If possible, how to do it? Thanks!

I have an ipsec vpn and it is up and running. On the remote asa I have the on the acl for the crytomap the inside network and destination the remote private network. I have also created a service policy rule where web traffic will not go to this tunn...

 Hi All, I am catalyst 3560 switch with IOS version 12.4(55). I have configured my switch to get access to CISCO Configuration Assistance tool, but it is not authenticating to my tool even i give correct usernames and passwords. Giving you the config...