Ashley
You would probably have got a response if you had posted in the correct forum ie. this is nothing really to do with VPN. The firewalling or more likely the LAN Switching/Routing forums would have been a better choice. So that is probably why you didn't get a response because we do try to help
That said, the general answer to your question is it really does depend on how secure your requirements are. So a number of options -
1) use a dedicated firewall and route the vlans off that
2) use a router and ZBF or CBAC for each subinterface
3) use standard acls to limit the traffic between vlans
I have seen all the above used. If you have strict security requirements then firewalling each vlan is an option but it does get complicated. For most companies L3 acls on the vlan interfaces are usually enough.
So looking at each vlan you have -
1) management vlan. You would definitely want to restrict which IPs can access this vlan. Hopefully you have a set of defined IPs (which you may need to make static in DHCP) that can access the devices. You should also obviously be running SSH if supported to connect to devices
2) data vlan - what are you trying to do here. Stop the data vlan from accessing other vlans or stop other vlans accessing the data vlan. This and the VOIP vlan are probably the most open, simply because that is where the users reside.
So do you have specfic requirements for these vlans in terms of your company policy.
3) VOIP - see 2)
4) Vendors - this is the trickies one of the lot and can give so many headaches. It's very difficult to give vendors the access they need without then allowing them to see other parts of the network. A lot of this comes down to how much you trust your vendors. Obviously you would want to make sure that they cannot leave the vlan they are on.
Don't forget that as far as internal security is concerned firewalling/L3 acls is only one part of it and as you have said it can become very complex. Equally important is locking down the user desktop so they cannot modify settings etc, implementing L2 security features on devices eg. port security/DAI/STP bpduguard etc and use 802.1x authentication for access to the network.
Overall most networks i have come across rely on L3 acls internally to filter inter-vlan traffic + L2 security features. If there are any vlans critical to the business then they have been firewalled but firewalling every is a big adminstrative overhead.
With some routers/switches there is now also the option of vrf-lite which allows you to create multiple virtual routers on the same box. The good thing about this is that each has it's own routing table so unless you allow routes to be leaked between vrfs the 2 routing tables cannot see each other.
Hope some of this has helped. Any further questions please ask.
Jon
