spoke router, can it do on the same interface easyvpn and crypto?

[pamirian76]

so I would like to know if I have a cisco 800 series lets say with interface fa0/0 being my public interface.

can I have on this interface an easyvpn connection to a hub and a crypto map xyz connection to another hub?

all the tests I've done using gns3 indicate no. when I have both on the same interface only eazyvpn works. when I remove the eazyvpn from the interface then site to site works...

I know with a crypto map I can have different tunnels but my question is a crypto map and an eazyvpn on the same outside interface can it work.

if yes, do you have a configuration example of the 2 hubs and the spoke?

thank you very much!!

[pamirian76]

on another note,

let's say my spoke is running easy vpn and it's assigned to my outside interface and I have to setup another vpn tunnel to a different hub, how do you suggest I do this?

on my spoke I have 1 outside interface fa0/0 and 1 internet access with 1 dynamic ip that I get from my isp.