Hi,
I have multiple 1841 and 2811 routers that are running the IPBASE-M IOS software and I do not seem the be able to configure SSH for remote access. I have copied in the Version info below. Can you let me know if this is an IOS restriction and if so what IOS version I need for each router in order to deploy SSH??
Thanks,
bp1841>sh ver
Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SO
FTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 25-Oct-05 17:10 by evmiller
ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)
bp1841 uptime is 2 years, 5 weeks, 3 days, 17 hours, 41 minutes
System returned to ROM by reload at 16:45:38 UTC Wed Oct 29 2008
System restarted at 16:10:21 GMT Wed Oct 29 2008
System image file is "flash:c1841-ipbase-mz.124-1c.bin"
Cisco 1841 (revision 7.0) with 114688K/16384K bytes of memory.
Processor board ID FCZ115090W4
2 FastEthernet interfaces
1 Serial(sync/async) interface
DRAM configuration is 64 bits wide with parity disabled.
191K bytes of NVRAM.
31360K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
R1_BP#sh ve
Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(15)T9, RELEAS
E SOFTWARE (fc5)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2009 by Cisco Systems, Inc.
Compiled Tue 28-Apr-09 13:10 by prod_rel_team
ROM: System Bootstrap, Version 12.4(13r)T11, RELEASE SOFTWARE (fc1)
R1_BP uptime is 9 weeks, 4 days, 11 hours, 13 minutes
System returned to ROM by reload at 21:54:22 GMT Thu Sep 30 2010
System image file is "flash:c2800nm-ipbase-mz.124-15.T9.bin"
Cisco 2811 (revision 53.51) with 251904K/10240K bytes of memory.
Processor board ID FCZ132870SH
2 FastEthernet interfaces
2 Serial(sync/async) interfaces
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
63808K bytes of ATA CompactFlash (Read/Write)
Configuration register is 0x2102
R1_BP#
