08-12-2008 05:10 AM
Hello guys,
I have problem setting up VLAN/s on ASA5510. I downloaded the command reference for my current version (7.2)of ASA OS but no one of the commands worked on my device. The license is Security Plus so there are no license restrictions.
Do I have to pre-configure something on the ASA or is there any way to enable the switching module in the ASA?? My task is to configure Trunk between one of the physical ports on the ASA and 2960 switch to carry multiple VLAN/s.
Any help will be highly appreciated.
rvr
Solved! Go to Solution.
08-12-2008 05:21 AM
Here is an example of trunking configuration on the ASA:
interface GigabitEthernet0/1
description "Trunk Connectivity with switch"
speed 100
duplex full
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/1.100
vlan 100
nameif DMZ0
security-level 80
ip address 10.0.0.1 255.255.255.0
!
interface GigabitEthernet0/1.101
vlan 101
nameif DMZ1
security-level 81
ip address 10.1.0.1 255.255.255.0
No special trunking commands there.
Please rate if this helped.
Regards,
Daniel
08-12-2008 05:21 AM
Here is an example of trunking configuration on the ASA:
interface GigabitEthernet0/1
description "Trunk Connectivity with switch"
speed 100
duplex full
no nameif
no security-level
no ip address
!
interface GigabitEthernet0/1.100
vlan 100
nameif DMZ0
security-level 80
ip address 10.0.0.1 255.255.255.0
!
interface GigabitEthernet0/1.101
vlan 101
nameif DMZ1
security-level 81
ip address 10.1.0.1 255.255.255.0
No special trunking commands there.
Please rate if this helped.
Regards,
Daniel
08-12-2008 10:33 AM
Thanks, great,
rvr
08-12-2008 12:29 PM
I created the VlANs, created the trunk on the switch too but the PIX doesnt send any traffic over. Created VLAN 1, 2, 3 on both devices but cannot ping the PIX from the Switch (SVI Interfaces) and vise versa. The trunk port on the switch says trunking is OK.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide