VPN Anyconnect via MX 100
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-12-2023 11:21 AM
Hello, Have been using the VPN Anyconnect until a few weeks ago when authetication stopped. No changes done on the AD nor the firewall. However, i noted that the AD and LDAP group configs on the firewall populates but cannot be saved despite the "changes saved" notification. Once you refresh the browser while logged in the firewall, the changes dissapears and wmi error pops up. The credentials are ok. The firewall log shows successful VPN connection with the AD, but an error log after of "authenticate failed retval=7 - Authentication failure" Would appreciate if anyone could advice.
- Labels:
-
Community Feedback Forum
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-12-2023 11:28 AM
Try to reload the MX controller and check.
check some troubleshooting tips :
