VPN Client outbound thru PIX

[scottthomas]

I have a Cisco VPN client workstation going thru a PIX to estabilish a connection on the Internet. The configurations are correct - I have bypassed the PIX (connected directly to the Internet) and all works good. However, when I put a PIX between the client and the Internet, I get an active session but no traffic. No reply from pings, etc. How do I configure the PIX to allow this?

[scottthomas]

I got it to work. I created rules on the PIX to allow incoming traffic on IP port 50 (ESP), UDP port 500 (ISAKMP) and UDP port 10000. This allows one VPN connection at a time because of PAT.