05-19-2013 04:35 AM
Hi.
I create a VPN Server with my cisco hardware. I connect my computer with CISCO VPN CLIENT and the connection is succesfull, but my internet access in routed to the VPN, and i only want the VPN to access to local resources (Shared Folders, Printers, ...) not for "internet and navigation access"
How i can configure VPN Client or other settings for the vpn service will be only for local lan access?
Thanks you.
Regards, ...
05-23-2013 01:48 AM
When editing the Group Policy under Advanced -> Split Tunneling you can specify which IP networks you want to sent into the tunnel when setting up the VPN.
05-23-2013 06:37 AM
Hi,
Marcel is correct, for further information about split-tunneling on the ASA:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080702999.shtml
HTH.
05-23-2013 01:58 PM
Hi.
My router is a SRP527W and it haven't that option, is possible configure split tunneling in this router?
If no, Is there any other alternative?
Thanks u
05-23-2013 02:00 PM
Please provide the platform model and software version... I can do a research.
Thanks.
Portu.
05-23-2013 02:05 PM
Hi..
Model: | SRP527W, ADSL2+ AnnexA, 802.11n ETSI, 2FXS/1FXO |
Version ID: | V03 |
Hardware Version: | 4.0.0 |
Boot Version: | 1.1.17 (Jan 4 2010 - 21:15:46) |
Firmware Version: | 1.01.27 (007) Jun 15 2012 |
ADSL Firmware Version: | 0.78.0 |
Recovery Firmware: | 1.01.20 (011) |
Setup Wizard Version: | 20101106.00 |
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide