VPN question

[themcurtis]

Hi

I am trying to find out if there is a way to set a source interface for a VPN that is ran on the IOS. The router in question is a cisco 871

The config has Nat running with 5 IP's

Four of the are static entries ending in

.193 overload and assigned to the fast Ethernet port of the router

.194 assigned to a pc

.195 assigned to a pc

.196 assigned to a pc

.197 assigned to a pc

I am not sure as to what IP the router will listen for incoming VPN connections

[paolo bevilacqua]

All the interface address.

[themcurtis]

OK so if it is listening on all addresses with that have an effect on the client mapped to say .195?

[paolo bevilacqua]

No. Interface addresses are not static nat addresses.

[cdusio]

If you are asking what IP address the router will accept incoming connections on it's the interface that has ISAKMP enabled on it typically the outside interface.