Hello,I know how to configure VPN's site to site with ASA's and also know Static Routing tracking.Would like to know how to configure the two ASA's of the attached schemma.
Here is the question, is there any way to make vpn. Think that one router has subnet A in his inside. The other asa firewall has B and C networks. What I want is B and C can reach A via VPN. But the A should only reach B, it shouldnt reach C network....
hi allI am trying to setup a small site with cme and cue in single cisco 3825/3845/2801. The no of users in this branch will be 1001. Can I use same router for the purpose of cme and cue2. What is the max no of mailboxes can be supported in cue when...
Hi Guys,I have a problem where i can only get remote telnet access to one of my Cisco 7513's every third or fourth attempt. The server attempting the access is containted within our management device network. and is behing an ASA. However, form our O...
I have Altiga 3000 VPN concentrator trying to use RADIUS authentication on W2k3 boxes with IAS installed. Client is Cisco VPN version 4.8 and 5. Base group setup and logs in fine. When asking for user/pass, it always fails with error 427. looking at ...
Hi all!I have a 851 router with Easy VPN server and VPN client v4.8.I can connect to remote site and ping gateway with packet size less or equal 10232 bytes:C:\Documents and Settings\Administrator>ping -t 192.168.250.1 -l 10232Pinging 192.168.250.1 ...
Hi *,I have a problem getting my Aladdin USB eToken (using Aladdin eToken PKI-Client (formerly 'RTE') 4.55.44) up and running with Cisco VPN client (4.9.01.0100) under Mac OS X (10.5.6): The certificate on the eToken does not show up in the "certific...
we are running MPLS VPN using Tunnel0 interface , we go the frequent below error message in router conole , it seems clinet end router holding old SA, it is not refereshed. pl advise, urgentINCDR#*Dec 29 09:19:11.134: %CRYPTO-4-RECVD_PKT_INV_SPI: dec...
Hi,I've an 876 ISR Router with ADV IP Security IOS and configured SSL VPN's.It runs perfect until we buy a new Notebook with MS Vista.The answer From Cisco was, that we must install a new IOS/SSL VPN Client Version.Now we've installed IOS Version 12....
Hi all,m new to vpn, can any1 explain the diff. b/w dynamic vpn & site-2-site vpn, & things that shld be taken care of.m trying to create a dynamic vpn b/w remote & my secure computing SG720 FW.topology isSG720(remote)--PIX515--SG720(local)i have SG7...
I have rule that I want to stop logging the event. I unchecked the 'Log' checkbox for the rule and generated rules. The rule is still logging events. So what do I have to do to stop the rule from logging (I don't want to disable it, just stop log...
I currently have an ASA5520 and about 15 5505s set up with site to site vpn connections. A few of the 5505 are connected via cable modems and their IPs change without notice. There is too much of a hassle to get static IPs. So i've been looking into ...
Hi All,I have configured the firewall and it is working perfectly.I have configured CSC Module also for URL Blocking. It is perfectly blocking the configured sites. Now a new requirement araised. This URL Blocking has to be configured to block the si...
Hi!!!Shortly topology: ASA 5510, clients connected on dialup using Cisco VPN Client. Connection is adjusted automatically, i.e. Windows XP starts VPN Client, it in turn starts dialup connection. And so a problem essence: At breakage dialup connection...
Hello AllI have some basic questions regarding ISAKMP Certificate based authentication betweencisco routers. Specifically when two peers exchange certificates during the authenticationphase and establish the fact that these come from a mutually trust...
