Hello,
We currently have a VPN tunnel with ASA's at each site. It is working correctly as of right now. I would like to add another subnet that exists at our Site A so that I can manage the equipment at Site B that exists on a different subnet. When I go to add the subnet to the Local Network and Remote Network on the ASA's, the tunnel goes down and does not come up until I remove the subnet.
We have a management subnet that is 10.x.x.x (Site A), this is the subnet I want to add to the VPN tunnel that can route with 192.168.47.x.
Existing subnets over the tunnel that can communicate with one another are 192.168.14.x(Site A) and 192.168.47.x (Site B)
Would someone be able to assist on which commands I need to add to each ASA to complete this task? I think I may be forgetting some NAT rules? I can provide run configuration as well.
