Hi,
Just bought 3 WRVS4400N, I wanted to setup gateway to gateway VPN. I followed the instructions on the WRVS4400N admin guide and VPN does not connect. I also downloaded the VPN setup wizard and that also did get the gateway connected. Everything seems to be correct. Do I have to enable anything else? Firewall setting?
Below is my config.
IPSec VPN Tunnel: Enabled
Tunnel Name: TUN01
Local Security gateway: IP only
WAN1 IP: 192.168.100.1
SUBNET: 255.255.255.0
Local Security type: subnet
LOCAL IP: 10.10.10.1
SUBNET: 255.255.255.0
Remote Security gateway: IP Only
WAN2 IP: 192.168.200.1
SUBNET: 255.255.255.0
Remote Security Group Type:
LOCAL IP: 10.10.20.1
SUBNET: 255.255.255.0
IPSec Setup
Keying Mode: IKE with PreShared Key
Phase 1:
Encryption: 3DES
Authentication: MD5
Group: 768-bit
Key Lifetime: 86400 sec
Phase 2:
Encryption: 3DES
Authentication: SHA1
Perfect Forward Secrecy: Enabled
Preshared Key: ABCD1234
Group: 768-bit
Key Lifetime: 28800 sec
