12-03-2013 01:58 AM
I have an Ironport S160 which has been off line and spare.
Our other live S160 developed a fault and was replaced with an S170 which is now up and running.
I am looking to update the spare S160 with the configuration file for the faulty S160.
My problem is that I cannot access any aspect of the configuration for the spare 160.
I have tried accessing the GUI but think I may have the incorrect IP address.
I have tried using a serial console cable to connect via the command line but it will not connect.
I am using the serial setting as suggested in S160 documentation.
Any suggestions?
Thanks in advance...
Seán
Solved! Go to Solution.
12-06-2013 04:29 AM
just for clarification - you cannot acces SPARE S160 Ironport?
Even if you have modified the default configuration and you cannot access the GUI, you should by able to access the appliance via serial console in any case. Using the serial settings as described should enable you to see the start/boot messages after powering up the appliance. At least, you should be presented with a login screen.
If not, verify your settings by connecting to the new S170 appliance. If it does not work, your setting/serial cable/serial port on laptop is damaged. If it works, so the spare c160 is damaged/faulty, too.
Another point is, if you get the login screen on the C160, but you can not login (password forgotten), bear in mind there is no password recovery implemented on Ironport appliances. You have to open a TOC and provide the Support Engineer with serial number of C160 appliance.
Darius
12-06-2013 04:29 AM
just for clarification - you cannot acces SPARE S160 Ironport?
Even if you have modified the default configuration and you cannot access the GUI, you should by able to access the appliance via serial console in any case. Using the serial settings as described should enable you to see the start/boot messages after powering up the appliance. At least, you should be presented with a login screen.
If not, verify your settings by connecting to the new S170 appliance. If it does not work, your setting/serial cable/serial port on laptop is damaged. If it works, so the spare c160 is damaged/faulty, too.
Another point is, if you get the login screen on the C160, but you can not login (password forgotten), bear in mind there is no password recovery implemented on Ironport appliances. You have to open a TOC and provide the Support Engineer with serial number of C160 appliance.
Darius
12-06-2013 04:35 AM
I have connected successfully to our S170 with the same laptop and serial cable.
The settings were the same also.
I'm not getting anything on the screen when hooked up to the S160. No prompt for credentials or anything else.
I think there has to be a fault with the unit.
Thanks for your response though.
Seán
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide