Separate default route for P1 and P2

[poulid]

Hi there. Is it possible to configure P1 and P2 on a Cisco WSA so that they each have their own default route? 

[amojarra · Accepted solution]

Hi @poulid 

Having two default routes (0.0.0.0/0) for P1 and P2 is not possible, However you can configure static routes and define the gateway which is corresponding to P1 or P2.

for Example : 10.0.0.0/8 -> P1's gateway and 0.0.0.0/0 P2's gateway .

+++++++++++++++++++++++++++++++++++++++++++++++++++

++++   If you find this answer helpful, please rate it as such  ++++

+++++++++++++++++++++++++++++++++++++++++++++++++++

[balaji.bandi]

You have manually make static Routes.

[poulid]

Dang. Ok, thx for the responses folks.