08-22-2022 02:35 PM
Hi there. Is it possible to configure P1 and P2 on a Cisco WSA so that they each have their own default route?
Solved! Go to Solution.
08-23-2022 09:27 AM
Hi @poulid
Having two default routes (0.0.0.0/0) for P1 and P2 is not possible, However you can configure static routes and define the gateway which is corresponding to P1 or P2.
for Example : 10.0.0.0/8 -> P1's gateway and 0.0.0.0/0 P2's gateway .
+++++++++++++++++++++++++++++++++++++++++++++++++++
++++ If you find this answer helpful, please rate it as such ++++
+++++++++++++++++++++++++++++++++++++++++++++++++++
08-23-2022 09:27 AM
Hi @poulid
Having two default routes (0.0.0.0/0) for P1 and P2 is not possible, However you can configure static routes and define the gateway which is corresponding to P1 or P2.
for Example : 10.0.0.0/8 -> P1's gateway and 0.0.0.0/0 P2's gateway .
+++++++++++++++++++++++++++++++++++++++++++++++++++
++++ If you find this answer helpful, please rate it as such ++++
+++++++++++++++++++++++++++++++++++++++++++++++++++
08-23-2022 09:43 AM
You have manually make static Routes.
08-23-2022 04:02 PM
Dang. Ok, thx for the responses folks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: