08-20-2013 02:19 PM
Hi
I am trying to setup the following service: ( managed service)
cisco ios router-887A (wccp v2)------internet -------Data Center ----ironport
is it possible to use ironport in the cloud and use for many clients ?
I was trying diffrent config and
scenario with wccp but without any success.
I started to doubt whether it is at all possible
Thanks for any advise
Best
Martin
08-20-2013 09:55 PM
Hi Marcin,
In order to know if this will work or not you will need to engage the router TAC or post this question in regards to the model of the router your using. I would also include the topolgy as what protocol your using to connecto the data center. Even though you list internet bewteen router 887 A and Data Center there has to be some sort of dedicated connection between the 2 devices in order for WCCP to work.
Sincerely,
Erik Kaiser
WSA CSE
WSA Cisco Forums Moderator
08-20-2013 11:14 PM
Hi Eric
Thx for your answer.
But generally WCCPv2 is the GRE tunnel - also we have dedicated connection to proxy . What is beeing use for your scansafe solution if you configure it on cisco ios ( WCCP too or something else ? ) ? for ASA I know there is dedicated part of code./configuration
Regs
Marcin
08-21-2013 11:03 PM
In regards to the WSA being in the cloud - Yes it is possible for many users to use it for Explicit Forward requests. Just keep in mind that you will need some other piece of hardware that will allow/reject requests based on IP in front of the WSA.
Regarding the WCCP, there is one detail that needs to be clarified with the Router team; will the WCCP redirection via GRE be NAT'd and passed through the internet to your datacenter?
-Vance
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide