Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiDoes anyone configure pim-ssm in vPC domain ? I am looking for some config/experience before I start. I know that PIM-SSM in vPC is only supported with FabricPath licencse which I allready got it. RegsMartin
HiWe are implementing DDoS solution in our network and the netflow protocol is lunch on core routers - the CRS-3I've got the folloing monitor-map:flow monitor-map arbor-ddos-mpls record mpls ipv4-fields exporter arbor-ddos cache timeout active 30 cac...
HiI am a little confuse with igmp querier on Nexus 5548UPI have the following configuration on both VPC peers: vlan configuration 208 ip igmp snooping version 2 ip igmp snooping querier 192.168.201.104 But the question is shell I use the same IP fo...
Hi I am trying to setup the following service: ( managed service) cisco ios router-887A (wccp v2)------internet -------Data Center ----ironportis it possible to use ironport in the cloud and use for many clients ? I was trying diffrent config and sc...
Hi I am fighting with the same case: CRS-2-Nexus via bundle + BGP and still no success I have got 4.2.4 on CRS-3 - I am goint to open the case for this issue. It looks for me like a bug in 4.2.0 software.Check the output form sho bfd session. Do you ...
Hi EricThx for your answer. But generally WCCPv2 is the GRE tunnel - also we have dedicated connection to proxy . What is beeing use for your scansafe solution if you configure it on cisco ios ( WCCP too or something else ? ) ? for ASA I know there...
