Buy or Renew
Buy or Renew

Web Security

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Forum Posts

Start a conversation

URL reporting

Currentrly using Sawmill for Iromport reporting and when I run a report against a specific website using a wildcard I am only getting seven URLs returned a being logged. I am expecting a much larger number of URL from this one specific web site. Do I...

jwalzer by • Beginner
  • 659 Views
  • 1 replies
  • 0 Helpful votes

WSA L4TM and scorecardresearch.com

Good morning!So we're running reports on a daily basis to gather information on our environment and have recently enabled L4 detections on our Ironport WSA's. I have noticed an extremely large number of detections for the domain "scorecardresearch.co...

DCS NSO by • Beginner
  • 599 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Block all Russia IP Addresses

Recently we have been taksed buy C level executives to block all ip communication to Russia. They are about 65,000 (CIDR aggregated) public ip addresses in China.  I dont want to manage an ACL with 65,000 entries not to mention how much larger it get...

efrazee by • Beginner
  • 3314 Views
  • 3 replies
  • 0 Helpful votes

Allowing SugarSync

Our Ironport S160 seems to be allowing cloud based services such as Dropbox and Amazon, but for some reason SugarSync fails to work through the WSA.  I freely admit that I'm not very experienced with this product (I didn't set it up in the first plac...

Steps to enable Web Proxy for https

I have an S160 WSA and want to enable the Web service for http and https. I am using transparent mode with WCCP. This is part of the router configuration:ACL:access-list 110 permit tcp 192.168.80.0 0.0.7.255 any eq 80 access-list 120 permit tcp 192.1...

slizarraga by • Beginner
  • 4236 Views
  • 3 replies
  • 0 Helpful votes

Ironport S160 7.5 & HTTPS

Hi,I recently set up a new Ironport identity group and access policy to assign to the new group.I can't seem to get HTTPS web sites working with this goup, it seems to just get dropped by the proxy.HTTPS is working fine for the exisiting access polic...

Berz123 by • Beginner
  • 2186 Views
  • 2 replies
  • 0 Helpful votes

Resolved! IronPort windows activation

Hello,I have a IronPort S170 and I am trying to activate windows online for workstations that use ironport.On the workstation i get the 0x80072f8f error.I have tried activating windows without going through Ironport and works fine.Is there a way I ca...

Ask the Expert: Best Practices for Configuring the Cisco Web Security Appliance (WSA)

With Juan RamosWelcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn how to configure, troubleshoot, and optimize the Cisco Web Security Appliance (WSA) with Cisco technical support expert Juan Daniel Ram...

WSA deployment question

We currently have and inline content filter we are upgrading to a Cisco WSA.  I am in the final stages and I have a couple of questions in regards to the deployment of the device.  I would like to use WCCP to do this and I have a few questions.Curren...

Ironport Initial Setup

Hi all,I just setup an ironport S160 appliance on my network. The applaince shows to be up but it does not seem to be capturing users activities. the following are the configuration details:Mode: Transparentdata interface: P1 onlymngt int: management...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers
Spotlight Award Nomination