WSA - multiple failover groups

[Erik Molnar]

Dear Community,

We have a deployment about four WSA proxy's that we would like to group into failover groups to add atleast one VIP address to each WSA proxy.

Is there anybody who has this kind of configuration? How is the priorities configured for each failover group?

Thank you in advance.

Best Regards,

Erik Molnar

[Tao Yang]

We have a couple of customer configuring like that. However please bear in mind the priority is within the same HA group.

[andresmen598]

Good day,

I would like to know if there is any document showing the step by step to perform load balancing and HA configuration between a WSA and vWSA through WCCP on a Cisco ASA Firewall.

On the other hand I have the doubt when this type of configuration is done as it is done so that when making some configuration change replicate in the two WSA (physical WSA and virtual vWSA).

Thank you in advance for the collaboration and help you give me.

[Prab]

Hi,

The configuration changes are not replicated from one Failover peer to another. You could use Cisco Security Management Appliance (SMA) for centralized configuration.

Cheers,

Prab